Every Single CalculatorOne place for every calculator

Calculators for welders and fabricators

Steel weight, filler metal and layout. 15 calculators, with the ones used most at the top.

Used most

  1. 1Steel weight calculatorWeight of steel, stainless or aluminum plate, flat bar and round bar.
  2. 2Weld metal calculatorWeight of filler metal for a steel fillet weld of a given size and length.
  3. 3Welding heat input calculatorHeat input of an arc weld in kilojoules per inch from volts, amps and travel speed.
  4. 4Bolt circle calculatorStraight-line distance between holes equally spaced on a bolt circle.
  5. 5Bend allowance calculatorBend allowance and bend deduction for sheet metal, to find the flat length.

Used often

  1. 6Pipe weight calculatorWeight of steel pipe or round tube from its outside diameter and wall.
  2. 7Diagonal calculatorCorner-to-corner diagonal for squaring up a deck, slab, wall or foundation.
  3. 8Right triangle calculatorLong side, angles and area of a right triangle from its two short sides.
  4. 9Circle calculatorCircumference and area of a circle from its diameter.
  5. 10Decimal to fraction calculatorTurn decimal inches into the nearest tape measure fraction.
  6. 11Rolling offset calculatorTravel and run for a pipe offset that moves over and up at the same time.
  7. 12Shielding gas calculatorHours of welding from a cylinder of shielding gas at a given flow.

Now and then

  1. 13Ring roll length calculatorFlat length of bar or plate to roll into a ring of a given inside diameter.
  2. 14Cone layout calculatorFlat pattern for a cone or a tapered transition, from its diameters and height.
  3. 15Sheet metal gauge calculatorThickness and weight of steel sheet from its gauge number.

The order is our judgement of how often each sum comes up on the job. If you would rank them differently, or one is missing, tell us. See every trade.