Every Single CalculatorOne place for every calculator
ΩPlumbing, HVAC and electrical

Rolling offset calculator

Enter how far a pipe has to move sideways and how far it has to move up to find the length of the angled piece.

Example: A pipe has to shift 12 inches over and 9 inches up to clear a duct, and you are using 45 degree fittings.

Your numbers

A rolling offset changes position in two directions at once. Offset is the sideways move and rise is the vertical move, both measured center to center.

in
in
  • Travel, center to center0
  • True offset0
  • Run0
  • Multiplier0

How it is worked out

First find the true offset, which is the diagonal of the sideways and vertical moves. Then multiply by the figure for the fitting angle.

True offset = √(offset² + rise²)

Travel = true offset × multiplier

  • 22.5 degree fittings: multiplier 2.613
  • 30 degree: 2.000
  • 45 degree: 1.414
  • 60 degree: 1.155

A worked example

A pipe that moves 12 inches sideways and 9 inches up has a true offset of 15 inches. With 45 degree fittings the travel is 15 × 1.414, which is 21 3/16 inches center to center, and the run along the pipe is 15 inches.

Good to know

  • Travel is measured between the centers of the two fittings. To get the cut length of the pipe, take off the fitting allowance at each end and add back the depth the pipe goes into each socket. Those figures come from the fitting maker.
  • With no rise, this is a plain offset. Leave the rise at 0.
  • Dry fit before you glue, solder or thread anything.

Common questions

Does this work for conduit?

The geometry is the same, but conduit is bent, not fitted. The conduit offset calculator gives bend marks and shrink.

How we know this calculator is right

Before this calculator went on the site, 10 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: electricians, plumbers and pipefitters, welders and fabricators.