How the amount is worked out
A hole is a cylinder. Its volume, less the part the post takes up, is the concrete you need.
Volume per hole = (3.1416 × (diameter ÷ 2)² − post width²) × depth
A worked example
A hole 10 inches across and 30 inches deep holds 2,356 cubic inches. A 4x4 post, which is really 3½ inches square, takes up 368 of that. The rest is 1.15 cubic feet of concrete per hole. Ten holes need 11.5 cubic feet, which is 31 bags of the 50 lb size or 20 of the 80 lb size.
Good to know
- A 50 lb bag of fast-setting mix makes about 0.375 cubic feet. An 80 lb bag of standard mix makes about 0.6.
- A common rule is a hole three times the width of the post, with a third of the post in the ground. Go below the frost line where the ground freezes.
- Put a few inches of gravel in the bottom of the hole first so water can drain away from the end of the post.
- Deck piers that carry a structure are sized by code. This calculator gives the volume once you know the size.
- Call 811 before you dig.
Common questions
How many bags per fence post?
For a 4x4 post in a 10 inch hole 30 inches deep, about three 50 lb bags or two 80 lb bags.
Can I use this for a form tube?
Yes. Enter the inside diameter of the tube and its full height, with the post width at 0.
How we know this calculator is right
Before this calculator went on the site, 10 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.