Every Single CalculatorOne place for every calculator
◧Interior finishes

Self-leveling compound calculator

Enter the area of the floor and the average thickness of the pour to find how many bags of leveler to buy.

Example: A kitchen floor dips half an inch in the middle and it has to be flat before the tile goes down.

Your numbers

A 50 lb bag makes roughly half a cubic foot, which covers about 48 square feet at ⅛ inch. Yields differ, so check the bag.

sq ft
in
cu ft
  • Bags to buy0
  • Volume0
  • One bag covers0

Self-leveling compound calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How the amount is worked out

Bags = area × (thickness ÷ 12) ÷ yield per bag

A worked example

One hundred square feet at an average of a quarter inch is 2.08 cubic feet. At half a cubic foot per bag that is 4.2, so you buy 5. Each bag covers 24 square feet at that thickness.

Good to know

  • The average thickness is the hard part. Find the high point of the floor, then measure how far below it the low spots are. Half the deepest dip is a fair average for a floor that dips in the middle.
  • Leveler sets fast and cannot be topped up once it skins over. Have every bag open and a helper mixing before you start pouring.
  • Prime the floor first. Unprimed concrete sucks the water out and the leveler will not flow.
  • Each product has a minimum and maximum thickness per pour. Deep fills may need aggregate added or a different product.

Common questions

Should I buy extra?

Yes. Running out part way leaves a ridge that has to be ground down. Most stores take back unopened bags.

How we know this calculator is right

Before this calculator went on the site, 6 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: concrete contractors, flooring installers, tile setters.