Every Single CalculatorOne place for every calculator
ΩPlumbing, HVAC and electrical

Pipe expansion calculator

Enter the pipe material, the length of the run and the temperature change to find how much it expands.

Example: You are running 80 feet of CPVC hot water line across a basement and need to know how much movement to allow.

Your numbers

Plastic pipe moves several times more than metal. Long hot runs need room to move.

ft
°F
Drawn from your numbers. It redraws as you type.
  • Expansion0
  • Per 100 ft of pipe0

How it is worked out

Expansion = coefficient × length in inches × temperature change

A worked example

One hundred feet of copper heated by 100 degrees grows 1.13 inches. The same run in CPVC grows about 4 inches.

Good to know

  • Coefficients used, in millionths of an inch per inch per degree F: copper 9.4, steel 6.5, PVC 30, CPVC 34, PEX 92.
  • Allow for movement with loops, offsets or expansion joints, and do not clamp long runs hard at both ends.
  • Use the pipe maker's figures for a design. Products vary.

How we know this calculator is right

Before this calculator went on the site, 4 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: plumbers and pipefitters, hvac technicians.