Every Single CalculatorOne place for every calculator
mpgVehicles, fuel and shipping

Torque conversion calculator

Enter a torque figure and its unit to see it in the others.

Example: The manual gives a spec in newton-meters and your torque wrench reads in foot-pounds.

Your numbers

Service manuals mix units. Small fasteners are often given in inch-pounds, and the two are easy to confuse.

  • Foot-pounds0
  • Inch-pounds0
  • Newton-meters0

How it is worked out

1 foot-pound = 12 inch-pounds = 1.3558 newton-meters

A worked example

A lug nut spec of 100 foot-pounds is 1,200 inch-pounds or 135.6 newton-meters.

Good to know

  • Mixing up inch-pounds and foot-pounds is a factor of 12. It strips threads or leaves bolts loose.
  • Use the figure and the tightening order in the service manual for the job.

How we know this calculator is right

Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: mechanics, unit conversions.