Every Single CalculatorOne place for every calculator
◧Interior finishes

R-value calculator

Choose the kind of insulation and the R-value you are aiming for to find how thick it has to be.

Example: An attic has 4 inches of old fiberglass and code now calls for R-38. Find out how much to blow in on top.

Your numbers

Choosing a material fills in a typical R-value per inch. The real figure is printed on the product, so change it to match.

R-38 to R-60 is common for attics.
in
Of the same material.
Drawn from your numbers. It redraws as you type.
  • Thickness to add0
  • Total thickness for the target0
  • R-value you have now0
  • R-value still needed0

How the thickness is worked out

Thickness = R-value needed ÷ R-value per inch

A worked example

Reaching R-38 with fiberglass at R-3.2 per inch takes 11.9 inches. If there are already 4 inches in place, that is R-12.8, so you need another 7.9 inches.

Typical R-values per inch

  • Fiberglass batt: about 3.2
  • Blown cellulose: about 3.6
  • Mineral wool batt: about 4.0
  • Open-cell spray foam: about 3.7
  • Closed-cell spray foam: about 6.5
  • Foam board: about 4.0 for EPS, 5.0 for XPS and 6.0 for polyiso

These are typical figures. Products vary, and blown insulation settles, so use the number on the label or the bag chart.

Good to know

  • The R-value your code requires depends on your climate zone and on whether it is an attic, wall or floor.
  • Compressing a batt lowers its total R-value. A thick batt squeezed into a shallow cavity does not perform as labelled.
  • Air sealing matters as much as R-value. Seal gaps and penetrations before you insulate.

How we know this calculator is right

Before this calculator went on the site, 10 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: hvac technicians, insulation installers.