Every Single CalculatorOne place for every calculator
⌂Roofing

Starter strip calculator

Enter the length of your eaves and rakes to find how many bundles of starter strip to buy.

Example: The shingle order is in and you need starter for 80 feet of eave and 72 feet of rake.

Your numbers

Starter strip always goes along the eaves. Many shingle makers also call for it up the rakes, especially for wind warranties.

ft
ft
ft
Often 100 to 120. Check the wrapper.
%
  • Bundles of starter0
  • Edge to cover0
  • With waste0

Starter strip calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How the amount is worked out

Bundles = (eaves + rakes) × (1 + waste) ÷ coverage per bundle

A worked example

A gable roof with 80 feet of eave and 72 feet of rake has 152 feet of edge. With 5% waste that is 159.6 feet, which takes 2 bundles at 100 feet each. Eaves only would take 1.

Good to know

  • Starter strip has a line of sealant at the edge that bonds the first course of shingles down against the wind.
  • You can cut starters from three-tab shingles by removing the tabs, but purpose-made strip is faster and the sealant is in the right place.
  • Let the starter overhang the drip edge by a quarter to three quarters of an inch, as the shingle maker specifies.

Common questions

Is this included in the roof estimator?

No. The roof estimator lists shingles, underlayment, drip edge, ridge cap and nails. Add starter from this page.

How we know this calculator is right

Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: roofers.