How the roll count is worked out
Each course of underlayment overlaps the one below it, so you need more than the bare roof area. Add an allowance, divide by what one roll covers and round up.
Rolls = roof area × (1 + overlap and waste) ÷ coverage per roll
A worked example
A 1,500 square foot roof with 10% for overlap needs 1,650 square feet. With 15 lb felt at 400 square feet a roll, that is 4.1 rolls, so you buy 5. The same roof takes 2 rolls of synthetic at 1,000 square feet each.
For the ice barrier, one 3 foot course along 80 feet of eave takes 2 rolls that are 66 feet long.
Good to know
- Ice and water barrier goes on first at the eaves and in valleys. In cold climates, codes commonly require it to reach at least 24 inches inside the heated wall line, which can mean two courses on a wide overhang.
- Low-slope roofs between 2/12 and 4/12 usually need double coverage. Set the allowance to 100% to estimate that.
- Synthetic underlayment is lighter and safer to walk on than felt, and one roll covers far more.
Common questions
Is 15 lb or 30 lb felt better?
30 lb felt is thicker and tears less, which helps on steep roofs and under heavier roofing. 15 lb is fine under shingles on an ordinary pitch. Follow the shingle maker's instructions to keep the warranty.
Does the ice barrier replace underlayment?
Only where it is laid. The rest of the roof still gets felt or synthetic, lapped over the top edge of the barrier.
How we know this calculator is right
Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.