Every Single CalculatorOne place for every calculator
</>Tech, screens and electronics

RC filter calculator

Cutoff frequency of a resistor-capacitor filter.

Example: You are building a tone control or smoothing a signal.

Your numbers

Ω
nF
  • Cutoff frequency0
  • Time constant0

How it is worked out

fc = 1 ÷ (2π × R × C)

A worked example

1 kΩ with 1 µF cuts off at 159 Hz.

Good to know

  • The same cutoff applies whether the parts are wired as a low-pass or a high-pass filter.

How we know this calculator is right

Before this calculator went on the site, 3 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: tech and screens.