Every Single CalculatorOne place for every calculator
▦Concrete and masonry

Concrete steps calculator

Enter the number of steps and their size to find how much concrete a solid flight of steps takes.

Example: You are pouring three solid steps to a front door and need to know how many bags to mix.

Your numbers

This is for solid steps cast in one block. Rise and run are for one step, in inches.

in
in
in
in
Enter 0 for none.
%
  • Concrete to order0
  • Volume0
  • Or 80 lb bags0
  • Total height0
  • Total length0

Concrete steps calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How the volume is worked out

Solid steps are a stack of slabs. The bottom step is one riser high, the next is two, and so on.

Volume = width × run × rise × steps × (steps + 1) ÷ 2

A worked example

Three steps, each 7 inches high and 11 inches deep and 36 inches wide, take 16,632 cubic inches, which is 9.6 cubic feet. With 10% extra that is 10.6 cubic feet, or 0.39 cubic yards. In 80 lb bags it is 18.

Good to know

  • Large flights are often filled with clean rubble or compacted gravel in the middle to save concrete. If you do that, your order will be lower than this figure.
  • Steps need a footing below the frost line, or they will lift and pull away from the house.
  • Keep every riser the same height. The common limits for houses are a riser no taller than 7¾ inches and a tread at least 10 inches deep.
  • Slope each tread forward by about an eighth of an inch so water runs off.

Common questions

How do I work out the rise and run?

The stair calculator divides the total height into equal risers.

How we know this calculator is right

Before this calculator went on the site, 8 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: concrete contractors, masons.