Every Single CalculatorOne place for every calculator
∟Framing and carpentry

Drywall calculator

Enter the size of a room to find how many sheets of drywall it takes to cover the walls and ceiling.

Example: You are hanging a 12 by 12 bedroom, walls and ceiling, and want to know whether to bring 8 foot or 12 foot sheets and how many.

Your numbers

Doors are counted as 21 square feet each and windows as 15. Set them to 0 if you prefer not to subtract openings.

ft
ft
ft
%
Drawn from your numbers. It redraws as you type.
  • Sheets to buy0
  • Area to cover0
  • Wall area0
  • Ceiling area0
  • Screws0

Drywall calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How the sheet count is worked out

Add up the area of the four walls and the ceiling, take out the doors and windows, add waste, and divide by the area of one sheet.

Wall area = 2 × (length + width) × ceiling height

Sheets = (walls + ceiling − openings) × (1 + waste) ÷ sheet area

A worked example

A 12 by 12 foot room with an 8 foot ceiling has 384 square feet of wall and 144 of ceiling. One door and two windows take out 51, leaving 477 square feet. With 10% waste that is 525 square feet. A 4 by 8 sheet covers 32, so you need 17 sheets. In 4 by 12 sheets it is 11.

Good to know

  • Longer sheets mean fewer joints to tape. Use 12 foot sheets where you can get them into the room.
  • Many installers do not subtract openings at all, because the cut-outs rarely get reused. Set doors and windows to 0 to estimate that way.
  • Half inch board is standard for walls. Ceilings with joists 24 inches apart need five eighths or a sag-resistant half inch board.
  • Bathrooms need moisture-resistant board, and garages attached to a house usually need fire-rated five eighths board on the shared wall and ceiling.

Common questions

How many screws do I need?

About one per square foot, which is 32 for a 4 by 8 sheet. The calculator uses that figure. A one pound box of 1¼ inch drywall screws holds roughly 300.

How much joint compound and tape?

As a planning figure, allow about 9 gallons of all-purpose compound, which is two 4.5 gallon buckets, and about 370 feet of tape for every 1,000 square feet of drywall. The joint compound calculator works it out for your area.

How we know this calculator is right

Before this calculator went on the site, 10 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: drywall hangers and finishers, remodelers and general contractors, handymen, homeowners.