Every Single CalculatorOne place for every calculator
ØWelding, machining, sheet metal and glass

Cone layout calculator

Flat pattern for a cone or a tapered transition, from its diameters and height.

Example: You are making a 12 to 6 inch reducer out of sheet.

Your numbers

For a pointed cone, enter 0 for the small diameter.

in
in
in
  • Outer radius of the pattern0
  • Inner radius0
  • Angle of the pattern0
  • Slant height0

How it is worked out

Slant = √(height² + ((large − small) ÷ 2)²)

Outer radius = slant × large ÷ (large − small)

Pattern angle = 360 × (large ÷ 2) ÷ outer radius

A worked example

A reducer from 12 inches to 6 inches, 8 inches tall, has a slant of 8.54 inches. Swing arcs of 17.09 and 8.54 inches from one point and mark off 126.4 degrees.

Good to know

  • Add a seam allowance along one straight edge.
  • Diameters are to the middle of the metal thickness.

How we know this calculator is right

Before this calculator went on the site, 8 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: welders and fabricators, sheet metal workers.