Every Single CalculatorOne place for every calculator
ØWelding, machining, sheet metal and glass

Weld metal calculator

Enter the leg size and length of a fillet weld to find the filler metal it takes.

Example: You are bidding a trailer frame with 60 feet of quarter inch fillet and need to know how much wire it burns.

Your numbers

A fillet weld is a triangle in section. Some of the electrode is lost as stub, spatter and slag, which is the efficiency.

in
ft
Drawn from your numbers. It redraws as you type.
  • Filler to buy0
  • Weld metal deposited0
  • Per foot of weld0

Weld metal calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How it is worked out

Weld metal = leg × leg ÷ 2 × length in inches × 0.2836 lb per cubic inch

Filler to buy = weld metal ÷ efficiency

A worked example

Ten feet of ¼ inch fillet is 0.03125 square inches in section and 120 inches long, so 3.75 cubic inches, which weighs 1.06 pounds. With MIG at 95% you need 1.12 pounds of wire.

Good to know

  • This is a flat-faced fillet in steel. Real welds are a little convex, so allow 10 to 20% more.
  • Doubling the leg size makes four times the weld metal. Oversized welds cost a lot.
  • Weld size for strength comes from the drawing or the engineer, not from this page.

How we know this calculator is right

Before this calculator went on the site, 5 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: welders and fabricators.