Every Single CalculatorOne place for every calculator
÷Everyday math

Plan scale calculator

Enter a measurement taken off a set of plans and the scale of the drawing to find the real length.

Example: The plans show a wall with no dimension on it, and you need its length off a quarter inch scale drawing.

Your numbers

The scale is printed in the title block or under each drawing. Floor plans are most often ¼ inch to the foot.

in
  • Real length0
  • In decimal feet0
  • Scale ratio0
  • In meters0

How it is worked out

Real length in feet = measurement on the drawing ÷ scale in inches per foot

A worked example

A wall measures 3½ inches on a ¼ inch scale plan. 3.5 ÷ 0.25 is 14, so the wall is 14 feet long.

Good to know

  • Use the written dimensions wherever the plans give them. Scale off the drawing only when a dimension is missing, and treat the answer as approximate.
  • Check that the print is at full size. Plans printed or copied to fit a smaller sheet are no longer to scale. If there is a scale bar on the sheet, measure it first.
  • An architect's scale rule reads directly in feet at each scale and saves the arithmetic.
  • Site plans often use an engineer's scale instead, such as 1 inch to 20 feet. For those, multiply the inches by the number of feet per inch.

Common questions

What does 1 to 48 mean?

It is the same as ¼ inch to the foot. One unit on the drawing is 48 of the same unit in real life.

How we know this calculator is right

Before this calculator went on the site, 9 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: remodelers and general contractors, estimators and business owners.