Every Single CalculatorOne place for every calculator
ΩPlumbing, HVAC and electrical

Watts, amps and volts calculator

Enter any two of volts, amps and watts, and leave the third empty. The calculator fills in the missing one.

Example: You want to know whether a 1,500 watt heater and a compressor can share one 15 amp circuit on site.

Your numbers

Leave exactly one box empty. In the US, ordinary outlets are 120 volts and large appliances are 240.

V
A
W
Drawn from your numbers. It redraws as you type.
  • Watts0
  • Amps0
  • Volts0
  • Kilowatts0
  • 80% of that0

The formula

For ordinary household loads, power in watts is volts multiplied by amps. Knowing any two gives you the third.

Watts = volts × amps

Amps = watts ÷ volts

A worked example

A 15 amp circuit at 120 volts can supply 1,800 watts. A 1,500 watt heater on that circuit draws 12.5 amps, which leaves very little for anything else.

The 80% figure

Electrical codes generally limit a load that runs for three hours or more to 80% of the circuit rating. For a 15 amp, 120 volt circuit that is 1,440 watts. The calculator shows 80% of whatever wattage it works out.

What this calculator does not do

It does not choose a wire size, a breaker or a conduit. Those depend on the length of the run, the temperature, how the cable is installed and the code where you are, and getting them wrong causes fires. Use the tables in your electrical code or ask a licensed electrician.

Common questions

Does this work for motors and three-phase power?

Not exactly. Motors and three-phase equipment need power factor and a different formula. This is for simple single-phase loads such as heaters and lights.

How do I find what an appliance draws?

Look for the rating plate on the back or underneath. It lists watts, or volts and amps.

How we know this calculator is right

Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: electricians, hvac technicians, solar installers.