Every Single CalculatorOne place for every calculator
∟Framing and carpentry

Board foot calculator

Enter the size of a board and how many you need to find the total board feet, and the cost if you know the price.

Example: The hardwood dealer prices walnut by the board foot and you need twelve boards for a table.

Your numbers

Hardwood and rough lumber are priced by the board foot. Thickness and width are in inches, length is in feet.

in
in
ft
$
Optional.
  • Total board feet0
  • Board feet per board0
  • Linear feet0
  • Cost0

How board feet are worked out

A board foot is a volume: one foot long, one foot wide and one inch thick, which is 144 cubic inches.

Board feet = thickness (in) × width (in) × length (ft) ÷ 12

A worked example

A board 2 inches thick, 6 inches wide and 10 feet long is 2 × 6 × 10 ÷ 12, which is 10 board feet. Twelve of them make 120 board feet.

Good to know

  • Board feet are worked out on the nominal size. A 2x6 is really 1½ by 5½ inches, but it is sold as 2 by 6.
  • Hardwood thickness is quoted in quarters of an inch. Four-quarter stock is 1 inch thick and eight-quarter is 2 inches.
  • Hardwood comes in random widths and lengths, so yards measure each board. Expect the bill to differ a little from your estimate.
  • For furniture and trim, allow 20% or more for defects and cutting around the grain.

Common questions

How do I convert board feet to linear feet?

Divide the board feet by the thickness times the width, then multiply by 12. For a 1x6, one board foot is 2 linear feet.

Is framing lumber sold by the board foot?

At most stores it is sold by the piece. Sawmills and wholesale yards often quote per thousand board feet.

How we know this calculator is right

Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: framers and carpenters, finish carpenters, cabinetmakers and woodworkers.