How the spacing is worked out
With a batten at each end, there is one fewer gap than there are battens. The calculator picks the number of battens that gets closest to the spacing you asked for, then spreads them evenly.
Gap = (wall width − battens × batten width) ÷ (battens − 1)
A worked example
A wall 144 inches wide with 2½ inch battens and a target of about 16 inches takes 9 battens. They use 22½ inches, leaving 121½ inches for 8 gaps, which is 15 3/16 inches each.
Good to know
- Cut a spacer block to the gap width. It is quicker and more accurate than measuring each batten.
- Check where outlets, switches and windows fall before you fix anything. Nudging the spacing by a fraction can keep a batten off a switch plate.
- Each batten is the height of the wall section, less the top rail and baseboard. Multiply by the count to get the length of trim to buy.
- Walls are rarely plumb or flat. Set each batten with a level, not by measuring from the corner.
Common questions
What spacing looks right?
Twelve to twenty inches is typical for an interior accent wall. Exterior board and batten siding usually has battens every 12 or 16 inches to cover the board joints.
How we know this calculator is right
Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.