Every Single CalculatorOne place for every calculator
∟Framing and carpentry

Crown molding angle calculator

Enter the spring angle of your crown and the angle of the corner to get the miter and bevel settings for cutting it flat on the saw.

Example: You are cutting crown flat on a compound saw for a 135 degree bay window corner and the chart on the saw only covers 90.

Your numbers

Spring angle is how far the crown tilts out from the wall. The most common crown is 38 degrees, often labelled 52/38. The other common one is 45.

°
Measure it. Few corners are exactly 90.
  • Miter setting0
  • Bevel setting0

How the settings are worked out

Crown sits at an angle between the wall and the ceiling, so a flat cut needs two angles at once: the table turned to a miter and the blade tilted to a bevel.

Miter = arctan(sin(spring angle) ÷ tan(corner angle ÷ 2))

Bevel = arcsin(cos(spring angle) × cos(corner angle ÷ 2))

A worked example

For standard 38 degree crown on a square 90 degree corner, the miter is 31.6 degrees and the bevel is 33.9. Most compound saws have detents marked at exactly those two settings. For 45 degree crown the settings are 35.3 and 30.

Good to know

  • These settings are for cutting the crown lying flat on the saw table. If you cut it upside down and leaning against the fence, set the bevel to 0 and the miter to half the corner angle.
  • Inside corners are usually coped, not mitred. A coped joint stays tight when the wood shrinks.
  • Which way the molding faces and which side of the blade the keeper is on changes for every cut. Mark the bottom edge and cut test pieces first.

Common questions

How do I find my spring angle?

Hold a piece in place against a framing square and measure how far it comes down the wall and out across the ceiling. Equal distances mean 45 degrees. Otherwise it is almost always 38.

How we know this calculator is right

Before this calculator went on the site, 6 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: finish carpenters, cabinetmakers and woodworkers.