Every Single CalculatorOne place for every calculator
ΩPlumbing, HVAC and electrical

Pipe offset calculator

Travel and run for a simple pipe offset with standard fittings.

Example: A drain has to jog 12 inches round a beam with two 45s.

Your numbers

The travel is the diagonal piece between the two fittings, centre to centre.

in
  • Travel, centre to centre0
  • Run0

How it is worked out

Travel = offset ÷ sin(angle). For 45° that is offset × 1.414

Run = offset ÷ tan(angle)

A worked example

A 12 inch offset with 45s has a travel of 12 × 1.414, or 16 15/16 inches, and a run of 12 inches.

Good to know

  • Take off the fitting allowance at each end to get the cut length of the pipe.
  • For an offset in two directions at once, use the rolling offset calculator.

How we know this calculator is right

Before this calculator went on the site, 6 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: plumbers and pipefitters.