How the amount is worked out
Multiply the length by the width to get the area, add a small allowance for waste, and divide by the coverage printed on the package.
Packages = length × width × (1 + waste) ÷ coverage per package
A worked example
An attic 40 by 30 feet is 1,200 square feet. With 5% waste you need 1,260 square feet. If one package covers 60 square feet, that is 21 packages.
Choosing insulation
- R-value measures resistance to heat flow. Higher is better, and the amount recommended depends on your climate and on whether it is an attic, wall or floor. Your local building code or energy office lists the target for your area.
- Batts and rolls come in widths made for framing 16 or 24 inches apart. Buy the width that matches your framing.
- Blown-in insulation is sold by the bag. The chart on the bag tells you how many square feet one bag covers at each R-value, and that is the figure to enter here.
- Faced insulation has a paper or foil vapour retarder on one side. Which side it faces depends on your climate, so check local practice.
Good to know
- Do not compress batts to fit. Squashed insulation loses R-value.
- Keep insulation clear of recessed lights unless they are rated for contact, and do not block the soffit vents. The attic ventilation calculator covers vent area.
- Wear gloves, long sleeves, eye protection and a dust mask when handling fibreglass or mineral wool.
Common questions
Should I subtract the framing?
Package coverage for batts already allows for standard framing, so use the full area.
Can I add new insulation over old?
Usually yes, in an attic, as long as the old insulation is dry. Use unfaced batts or blown-in on top so you do not trap moisture between two vapour retarders.
How we know this calculator is right
Before this calculator went on the site, 5 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.