How the length is worked out
Ramp run = rise × slope ratio
Runs = rise ÷ 30 inches, rounded up
A worked example
A door sill 24 inches above the ground needs 24 × 12, which is 288 inches or 24 feet of ramp. That fits in one run. A 60 inch rise needs 60 feet of ramp in two runs with a landing between them, which adds 5 feet.
Good to know
- Landings are needed at the top and bottom as well, each at least 5 feet long, and a turn needs a landing 5 feet by 5 feet.
- The standards also call for a clear width of at least 36 inches, handrails on both sides when the rise is more than 6 inches, and edge protection.
- A ramp at a private home may not be legally bound by these standards, but they are the right target. A steeper ramp is hard to climb and dangerous to come down.
- Check your local code and whether a permit is needed before you build.
Common questions
What if there is not enough room?
Switch the ramp back on itself with a landing at the turn, or consider a platform lift. Do not steepen the slope.
How we know this calculator is right
Before this calculator went on the site, 13 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.