How the volume is worked out
Gallons = surface area × average depth × 7.48
The surface area is length times width for a rectangle, and 3.1416 × (diameter ÷ 2)² for a round pool. An oval is length × width × 0.785. There are 7.48 gallons in a cubic foot.
A worked example
A rectangular pool 32 by 16 feet that slopes from 3.5 to 8 feet deep has an average depth of 5.75 feet. That is 2,944 cubic feet, or about 22,000 gallons.
Good to know
- The gallon figure is what chemical doses, pump sizes and heater sizes are all based on, so it is worth getting right once and writing down.
- Measure water depth, not wall height. The water line usually sits several inches below the top.
- Kidney and freeform pools can be treated as an oval of the same overall length and average width for a close estimate.
- A pool with a flat shallow section and a sudden drop holds a little more or less than the average-depth figure, depending on where the slope breaks.
Common questions
How long will it take to fill?
Divide the gallons by your hose flow. A garden hose gives roughly 8 to 10 gallons a minute, so 22,000 gallons takes around 40 hours.
How we know this calculator is right
Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.