Every Single CalculatorOne place for every calculator
◧Interior finishes

Shiplap calculator

Enter the size of the wall and the width each board covers to find how many boards to buy.

Example: A customer wants one wall of a living room in shiplap. Get the board count for the order.

Your numbers

Coverage is the face that shows once the boards overlap, which is less than the full board width. For a 1x6 shiplap board it is usually about 5¼ inches.

ft
ft
in
Check the product.
ft
%
Drawn from your numbers. It redraws as you type.
  • Boards to buy0
  • Rows0
  • Board length needed0
  • Wall area0

Shiplap calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How the board count is worked out

Rows = wall height × 12 ÷ board coverage, rounded up

Boards = rows × wall width × (1 + waste) ÷ board length

A worked example

A wall 12 feet wide and 8 feet high, with boards that cover 5¼ inches each, takes 19 rows. That is 228 feet of board. With 10% waste and 12 foot boards, you buy 21.

Good to know

  • This is for boards run horizontally. For vertical boards, swap the wall width and height.
  • Buy boards as long as the wall where you can, so there are no butt joints. Where joints are needed, stagger them from row to row.
  • Take out large windows and doors by reducing the wall width, but keep the waste figure up, since every opening means cuts.
  • Let the boards sit in the room for a few days first, and paint the tongues or the wall behind the gaps before you install.

Common questions

Does this work for tongue and groove or beadboard planks?

Yes. Enter the width each plank covers once it is locked into the next one.

How we know this calculator is right

Before this calculator went on the site, 8 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: finish carpenters.