Every Single CalculatorOne place for every calculator
%Bidding and business

Overtime pay calculator

Enter the hours worked in a week and the hourly rate to find the pay with overtime.

Example: A crew member worked 48 hours this week and you are checking the payroll figure.

Your numbers

Under US federal law, most hourly workers are paid time and a half for hours over 40 in a week. Some states and union agreements use daily overtime or double time.

$
hrs
1.5 is time and a half.
Drawn from your numbers. It redraws as you type.
  • Gross pay0
  • Regular pay0
  • Overtime pay0
  • Overtime hours0
  • Overtime rate0

How the pay is worked out

Gross pay = regular hours × rate + overtime hours × rate × multiplier

A worked example

Forty-eight hours at $30 an hour is 40 regular hours and 8 overtime. Regular pay is $1,200. Overtime at time and a half is $45 an hour, which is $360. Gross pay for the week is $1,560.

Good to know

  • This is gross pay, before tax and deductions.
  • Overtime is worked out per week, not averaged over two. Fifty hours one week and thirty the next still means ten hours of overtime.
  • Some states count overtime by the day, and some jobs under prevailing wage or union agreements have their own rules. Check what applies to you.
  • For an employer, overtime also raises payroll taxes and workers compensation. The labor cost calculator shows the full cost of an hour.

Common questions

How do I turn hours and minutes into a decimal?

Divide the minutes by 60. Seven hours and 45 minutes is 7.75 hours.

How we know this calculator is right

Before this calculator went on the site, 9 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: remodelers and general contractors, estimators and business owners.