How the tonnage is worked out
Find the volume in cubic feet, multiply by the weight of a cubic foot of compacted asphalt, and divide by 2,000 for tons.
Tons = length × width × (thickness ÷ 12) × weight per cubic foot ÷ 2,000
A worked example
A driveway 40 by 12 feet paved 3 inches thick is 120 cubic feet. With 5% extra that is 126 cubic feet. At 145 pounds per cubic foot it weighs 18,270 pounds, which is 9.14 tons.
Good to know
- As a quick check, one ton covers about 80 square feet at 2 inches thick.
- Asphalt is only as good as the base under it. A home driveway typically sits on 4 to 8 inches of compacted gravel.
- Plants sell by the ton and often have a minimum order. Small patches are usually done with bagged cold patch instead.
- Mix designs vary in weight. If the plant gives you a figure, use theirs.
Common questions
How thick should a driveway be?
Two to three inches of compacted asphalt is common for cars. Heavier vehicles need more, and commercial paving is laid in two or more layers.
How much gravel base do I need?
Use the gravel calculator with the same length and width and the depth of the base.
How we know this calculator is right
Before this calculator went on the site, 6 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.