How the stairs are worked out
Divide the total rise by the tallest riser you are allowed and round up. That is the number of risers. Divide the total rise by that number to get the exact height of each one, so every step is the same.
Risers = total rise ÷ tallest riser, rounded up
Stringer length = √(total rise² + total run²)
There is one fewer tread than risers, because the upper floor acts as the last step.
A worked example
A 108 inch rise divided by 7¾ inches is 13.9, so you need 14 risers. Each one is 108 ÷ 14, which is 7 11/16 inches. That leaves 13 treads. At 10 inches each the stairs run 130 inches, or 10 feet 10 inches, across the floor. The stringer is 14 feet 1 inch long and the stairs climb at just under 40 degrees.
Good to know
- The common residential limits are a riser no taller than 7¾ inches and a tread at least 10 inches deep. Your local code may differ, and commercial stairs are stricter.
- All risers in a flight should match to within three eighths of an inch. Uneven steps are a trip hazard.
- Buy stringer stock longer than the figure here. You need extra at both ends for the cuts, and 2x12 is the usual size.
- Leave at least 6 feet 8 inches of headroom above the line of the stair nosings.
Common questions
What if I do not have room for the total run?
You can add a landing and turn the stairs. You cannot make the treads shallower than the code minimum.
Does the stringer length include the top and bottom cuts?
No. It is the straight line from the bottom of the first riser to the top of the last. Add a foot or so when you buy the lumber.
How we know this calculator is right
Before this calculator went on the site, 15 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.