Every Single CalculatorOne place for every calculator
ØWelding, machining, sheet metal and glass

Steel weight calculator

Enter the size of a plate, flat bar or round bar to find what it weighs.

Example: You need to know whether two people can lift a quarter inch steel plate, or whether it needs the hoist.

Your numbers

Length is in feet. Width, thickness and diameter are in inches.

ft
in
in
in
Drawn from your numbers. It redraws as you type.
  • Total weight0
  • Weight per piece0
  • Weight per foot0
  • In kilograms0

How the weight is worked out

Find the volume in cubic inches and multiply by the density of the metal.

Plate: weight = width × thickness × length in inches × density

Round bar: weight = 3.1416 × (diameter ÷ 2)² × length in inches × density

Densities used are 0.2836 pounds per cubic inch for carbon steel, 0.289 for stainless and 0.0975 for aluminum.

A worked example

A quarter inch steel plate 12 inches wide and 10 feet long is 360 cubic inches, which weighs 102.1 pounds. A 1 inch round bar of the same length weighs 26.7 pounds, or 2.67 pounds per foot.

Good to know

  • Rolled steel varies slightly in thickness, so delivered weights can differ from the calculation by a few percent.
  • A handy check: a square foot of steel plate weighs about 40.8 pounds for every inch of thickness.
  • Angle, channel, beams and tube have their own weight-per-foot tables. Supplier catalogues list them by size.
  • Know the weight before you lift. Check it against the rating of your hoist, slings and truck.

Common questions

Does this work for rebar?

Roughly, but rebar has standard weights per foot that account for the ribs. The rebar calculator uses those.

How we know this calculator is right

Before this calculator went on the site, 9 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: plumbers and pipefitters, welders and fabricators, machinists, sheet metal workers.