Every Single CalculatorOne place for every calculator
ØWelding, machining, sheet metal and glass

Welding heat input calculator

Enter the arc voltage, the current and the travel speed to find the heat input.

Example: A procedure sheet limits heat input to 35 kJ per inch and you want to check your settings against it.

Your numbers

Travel speed is how far the weld moves in a minute. Time a measured length of weld to find it.

V
A
in/min
  • Heat input0
  • In kJ per mm0

How it is worked out

Heat input = volts × amps × 60 ÷ (1,000 × travel speed)

A worked example

At 24 volts, 200 amps and 12 inches a minute: 24 × 200 × 60 ÷ 12,000 is 24 kilojoules per inch.

Good to know

  • Welding procedures set a heat input range. Too high can weaken the steel next to the weld, too low can leave it brittle.
  • Slowing down raises heat input as surely as turning the machine up.
  • Some codes multiply by a process efficiency factor. This is the plain arc energy.

How we know this calculator is right

Before this calculator went on the site, 3 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: welders and fabricators.