Every Single CalculatorOne place for every calculator
⌂Roofing

Ladder calculator

Enter the height of the roof edge or landing to find how far from the wall to set the foot of the ladder, and how long the ladder needs to be.

Example: You are setting an extension ladder to a gutter 12 feet up and want the base in the right place before you climb.

Your numbers

The 4 to 1 rule: set the base 1 foot out for every 4 feet of height. A ladder used to get onto a roof should extend 3 feet above the edge.

ft
ft
3 ft is the standard.
Drawn from your numbers. It redraws as you type.
  • Set the base this far out0
  • Ladder length needed0
  • Length up to the edge0
  • Ladder angle0

How it is worked out

Base distance = height ÷ 4

Ladder length = √(height² + base²) + extension above the edge

A worked example

For a roof edge 12 feet up, the base goes 3 feet out from the wall. The ladder runs 12.4 feet to the edge and needs 3 feet more above it, so it must reach 15.4 feet.

Good to know

  • The sections of an extension ladder overlap by several feet, so its usable length is less than its nominal size. A ladder sold as 20 feet reaches about 17. Check the label.
  • Set the ladder on firm, level ground and tie it off at the top before you work from it.
  • Keep ladders well clear of power lines. Aluminum conducts electricity. Use fiberglass anywhere near wiring.
  • A quick check of the angle: stand with your toes at the feet of the ladder and reach straight out. Your palms should rest on a rung.

Common questions

Why 3 feet above the edge?

It gives you something to hold as you step on and off the roof, which is when most ladder falls happen.

How we know this calculator is right

Before this calculator went on the site, 8 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: roofers, painters, siding and gutter installers, solar installers.