Every Single CalculatorOne place for every calculator
▦Concrete and masonry

Wire mesh calculator

Sheets or rolls of welded wire mesh for a concrete slab.

Example: You are pouring a garage floor and ordering mesh with the concrete.

Your numbers

Mesh is lapped where pieces meet, usually by one square of the mesh.

ft
ft
%
Drawn from your numbers. It redraws as you type.
  • Sheets or rolls0
  • Slab area0

Wire mesh calculator. Estimate from everysinglecalculator.com

Materials list
ItemBuyHow it was worked out

How it is worked out

Pieces = slab area × (1 + overlap) ÷ area of one sheet or roll

A worked example

A 20 by 10 foot slab is 200 square feet. With 10% for laps that is 220, so 5 sheets of 5 by 10.

Good to know

  • Mesh only works in the middle of the slab. Hold it up on chairs, do not leave it on the ground.
  • Whether a slab needs mesh, bar or fibre is for the plans or an engineer.

How we know this calculator is right

Before this calculator went on the site, 3 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: concrete contractors.