How the block count is worked out
A standard block with its mortar joint covers 16 by 8 inches, which is 0.89 square feet. That works out to 1.125 blocks for every square foot of wall.
Blocks = wall area × 144 ÷ (block length × block height) × (1 + waste)
A worked example
A wall 20 feet long and 8 feet high is 160 square feet. At 1.125 blocks per square foot that is 180 blocks, and 5% waste brings it to 189. The wall is 12 courses high with 15 blocks in each. At 12 blocks per bag, the mortar comes to 16 bags.
Good to know
- The real block is ⅜ inch smaller each way than the sizes above. The joint makes up the difference.
- Corners, ends and openings use half blocks and special shapes. Tell the supplier how many corners and ends the wall has.
- Walls that hold back soil or carry a building need rebar and grout in the cores, on a footing sized for the load. That design comes from your code or an engineer.
- The footing calculator covers the concrete under the wall.
Common questions
How much mortar per block?
A common planning figure is one 80 lb bag of mortar mix for every 12 blocks. The bag lists its own yield.
Does block thickness change the count?
No. A 6, 8 or 12 inch thick block has the same face size, so the count is the same.
How we know this calculator is right
Before this calculator went on the site, 10 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.
See every check
| Numbers used | Result | Worked out separately | This calculator |
|---|
What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.