Every Single CalculatorOne place for every calculator
ØWelding, machining, sheet metal and glass

Sine bar calculator

Height of gauge blocks to set a sine bar to an angle.

Example: You are setting up to grind a 30 degree face.

Your numbers

The length is the centre distance of the rolls, usually 5 or 10 inches.

in
°
  • Block height0

How it is worked out

Height = length × sin(angle)

A worked example

For 30 degrees on a 5 inch bar: 5 × 0.5 is 2.500 inches of blocks.

Good to know

  • Above about 45 degrees a sine bar gets less accurate. Set the complement and work from the other face.

How we know this calculator is right

Before this calculator went on the site, 2 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: machinists.