Every Single CalculatorOne place for every calculator
ΩPlumbing, HVAC and electrical

Pipe friction loss calculator

Pressure lost to friction in a run of pipe, by the Hazen-Williams formula.

Example: A long irrigation main is starving the far heads and you want to know what the pipe is costing in pressure.

Your numbers

Use the true inside diameter. The C factor is about 150 for plastic, 140 for copper and 100 for old steel.

gpm
in
ft
Drawn from your numbers. It redraws as you type.
  • Pressure lost0
  • As feet of head0
  • Per 100 ft0

How it is worked out

psi lost per foot = 4.52 × gpm^1.852 ÷ (C^1.852 × diameter^4.8655)

A worked example

Ten gallons a minute through 100 feet of smooth 1 inch pipe loses about 3 psi.

Good to know

  • Doubling the flow nearly quadruples the loss. Going up one pipe size cuts it by about two thirds.
  • Fittings and valves add more. A common allowance is 10 to 20% on top.
  • This is for water. System design should follow the code or the maker's tables.

How we know this calculator is right

Before this calculator went on the site, 3 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: plumbers and pipefitters, irrigation installers.