Every Single CalculatorOne place for every calculator
ØWelding, machining, sheet metal and glass

Bend allowance calculator

Enter the thickness, inside radius and bend angle to find the bend allowance and bend deduction.

Example: You are folding a bracket with two 2 inch legs and need the blank length so it comes out right.

Your numbers

The K-factor is where the neutral line sits in the thickness. About 0.44 suits most air bending in steel, and 0.33 suits tight bends.

in
in
°
  • Bend deduction0
  • Bend allowance0
  • Outside setback0

How it is worked out

Bend allowance = angle in radians × (inside radius + K × thickness)

Bend deduction = 2 × tan(angle ÷ 2) × (radius + thickness) − bend allowance

Flat length = sum of the outside flange lengths − bend deduction

A worked example

For ⅛ inch steel with a ⅛ inch inside radius bent 90 degrees, the bend allowance is 0.283 inches and the bend deduction is 0.217. Two 2 inch outside flanges need a flat blank of 4 − 0.217, or 3.783 inches.

Good to know

  • The K-factor changes with material, tooling and method. Bend a test piece and measure it to find yours.
  • The bend angle here is how far the metal is bent, so a square corner is 90.

How we know this calculator is right

Before this calculator went on the site, 5 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: welders and fabricators, sheet metal workers.