Every Single CalculatorOne place for every calculator
◧Interior finishes

Tile layout calculator

Enter the width of the room and the size of your tile to find how many full tiles fit across and how big the cut tiles at the walls will be.

Example: You are about to tile a bathroom floor 10 feet wide and want to know whether to start from a tile or a joint so the cuts at the walls match.

Your numbers

The layout is centred, so the cut at both walls is the same. It avoids cuts smaller than half a tile, which look poor and are hard to make.

in
in
in
  • Cut tile at each wall0
  • Full tiles across0
  • Tiles across, including cuts0
  • Layout0
  • Cut if you add one more full tile0

How the layout is worked out

A centred row is a cut tile, then full tiles, then a matching cut tile, with a joint between each. Whatever is left after the full tiles and joints is shared between the two cuts.

Cut = (room width − full tiles × tile size − joints) ÷ 2

If the cut would be less than half a tile, the calculator drops one full tile. That makes both cuts bigger by half a tile and half a joint.

A worked example

A room 120 inches wide in 12 inch tile with ⅛ inch joints could take 9 full tiles with cuts of 5⅜ inches. That is under half a tile, so the better layout is 8 full tiles with a cut of 11 7/16 inches at each wall.

Good to know

  • Run the calculator for both directions of the room. Each has its own cut size.
  • Snap a chalk line through the centre of the room in both directions and dry lay a row before you mix anything.
  • The layout can be centred on a tile or on a joint. This works out both and shows the one with the larger cuts first.
  • Walls are rarely straight or square. Check the cut size at both ends of the wall before committing.
  • Sometimes it is better to shift the layout so a full tile lands at a doorway or the most visible wall.

Common questions

How many tiles do I need in total?

The tile calculator works out the count for the whole floor with waste.

How we know this calculator is right

Before this calculator went on the site, 13 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: flooring installers, tile setters.