Every Single CalculatorOne place for every calculator
ØWelding, machining, sheet metal and glass

Machining time calculator

Cutting time from the length of cut, feed rate and number of passes.

Example: You are quoting 50 parts and need the cycle time for each.

Your numbers

Use the feed in inches per minute from the speeds and feeds.

in
in/min
  • Cutting time0
  • Each pass0

How it is worked out

Time = length of cut ÷ feed rate × passes

A worked example

A 10 inch cut at 5 inches a minute takes 2 minutes. Three passes take 6.

Good to know

  • Add approach, overtravel, rapids and tool changes. They often double the cycle on short parts.

How we know this calculator is right

Before this calculator went on the site, 3 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: machinists.