Every Single CalculatorOne place for every calculator
ØWelding, machining, sheet metal and glass

Bolt circle calculator

Enter the bolt circle diameter and the number of holes to find the distance from one hole to the next.

Example: You are making a blanking plate to match a six-bolt flange and need to lay out the holes.

Your numbers

Set your dividers to the hole-to-hole distance and step round the circle.

in
  • Hole to hole, center to center0
  • Angle between holes0
  • Radius0

How it is worked out

Distance between holes = diameter × sin(180° ÷ number of holes)

A worked example

Six holes on a 6 inch circle are 6 × sin(30°) apart, which is exactly 3 inches. With six holes the spacing always equals the radius.

Good to know

  • To measure an existing flange with an even number of holes, measure straight across between opposite holes. That is the diameter.
  • Mark out from one scribed centre line so errors do not add up round the circle.

How we know this calculator is right

Before this calculator went on the site, 7 answers were worked out separately from its code, by hand or straight from the formula above. Each time this page loads, your own browser runs the calculator on those same numbers and compares. Turn on JavaScript to see the comparison.

See every check
Numbers usedResultWorked out separatelyThis calculator

What this proves: the calculator does the arithmetic of the formula shown, correctly. What it cannot prove: your measurements, or figures such as coverage per bag, waste and spacing, which are typical starting values you can change. Go by the product label and your local code.

Used by: welders and fabricators, machinists.